Sales & Support
Request A Quote -
Payment & Shipping Terms:
|Name:||Falling Film Evaporation Machine||Application:||Liquid|
|DIAMETER:||100 (mm)||HEAT EXCHANGER HTA:||0.12(m2)|
|FEED AMOUNT:||4~12 ( L/h)||Advantage:||Low Steam Consumption|
water evaporation machine,
Falling Film Evaporation Machine For Liquid Low Steam Consumption
Falling Film Evaporation Machine Main Characteristic
1. Whole system design reasonable,operation stable,high efficient energy saving,lower steam consumption.
2. Bigger concentration ratio,falling film type evaporator,short concentration time.
3. Special operation method designed for different product.
4. Whole system with high efficient,short heating time because of steam heating evenly, membrane type evaporation.it is more energy saving,steam consumption and cooling water lower if equipped TVR(Thermal Vapor Recompression)
5. Especially suit for food evaporation because of membrane state in each pipeline with short time,it keeps the food nutrition ingredient.
6. Evaporator adopt spray feeding or overflow membrane device, make sure material could flow evenly as membrane state, increased the heat exchange coefficient,prevent scaling phenomenon.
7. Equipment adopt vertical construction at side, it is tightly and space small,easy arrangement, it is the development direction of big scale evaporation system.
8. Vacuum evaporator,not merely make sure the material sanitary requirement,also ensure the environmental requirement,at the same time,decrease the evaporation temperature,if equipped the TVR(Thermal Vapor Recompression),part of secondary steam will be re- suction into 1st effect evaporator by TVR,heat energy will make full use of it,it suit for heat sensitive material.
9. Falling Film Evaporator suit for the material with foaminess,due to material evaporation as membrane state inside the heater,it will form steam-liquid separation,at the same time,mostly material will be pumped out from the bottom of evaporator,only little material and all secondary steam enter into the separator for continue separation,so there is no much impact during this evaporation,avoided foam forming.
10. Refer to food evaporation, this equipment with both function of sterilization and concentration,short heating time,suit for heat sensitive material.
Falling Film Evaporation Machine Parameters
|MATERIAL||stainless steel 304/S316L|
|TEMPERATURE||Room temp~200/300 ℃(depend on the Electric heater )|
|HEAT EXCHANGER HTA||0.12(m2)|
|FEED AMOUNT||4~12 ( L/h)|
|FILM SYSTEM||Wiped Filming System|
|VACUITY||0.1mbar(depend on the nature of material and vacuum pump)(vacuum pump not included)|
|FLOOR AREA||length*width*height=1200*500*1800 (mm)|
|POWER||150W (without pump)|
Contact Person: Ji