Automatic Medical Hemp CBD Producing Line Electric Powered Crusher Blender

Automatic Medical Hemp CBD Producing Line Electric Powered Crusher Blender

Electric Powered Crusher Blender Introduction

CBD can alleviate pain associated with multiple sclerosis, treat inflammation caused by a variety of conditions and treat epilepsy.

THC is an active ingredient in nabiximols, a specific extract of Cannabissativa that should be separate from CBD. Some governments regulate the concentration of THC and permit only hemp that is bred with an especially low THC content.

Cannabissativa (Hemp)has long been used for hemp fibre, for hemp oils, for medicinal purposes, and as a recreational drug.

Electric Powered Crusher Blender Main Features

1. The machine consists of the upper shell, the lower shell, the outlet, the feed hopper, the angle steel frame, the hammer blade , cutting tools, etc.

2. When crushing, the size of the crushing material is controlled by the size of the sieve, and the mesh can be replaced.

3. When cutting grass alone , you can put the screen out.

Electric Powered Crusher Blender Paramaters

Operational requirements

1. The machine should be mounted on a flat and firm site when working.

2. Before installing the belt, check whether the rotation direction of the index power is the same as that of the guillotine cutter, adjust the belt before adjusting the belt, and make its belt loose appropriate.

3. Check and adjust the clearance of the cutter before starting, so that the clearance adjustment can be controlled below 0.8 mm without collision, then lock the bolt.

Safety requirements

1. Before starting the machine, you must read the instruction manual, adjust and maintain it according to its fixed, operator must master the structure and function requirements of the machine.

2. Check the direction of operation before the start of the machine with the same direction as the guillotine, otherwise it is strictly forbidden to turn on the machine.

3. The material that needs cutting must not be mixed with metal, stone and other hard objects, otherwise it will cause machine damage.

4. After the machine has been running for a few hours, you need to see if the parts are loose, and you have to put butter on the bearings regularly.

5. When feeding a plant, the operator's hand must not be close to the blade to avoid causing personal injury accidents, feeding should be uniform, not too much or too little, time and time.