![]() |
|
|
Product Details:
Payment & Shipping Terms:
|
MATERIAL: | Stainless Steel 304 | TEMPERATURE: | Room Temp~200/300 ℃(depend On The Oil Heater) |
---|---|---|---|
DIAMETER: | 200 (mm) | HEAT EXCHANGER HTA: | 0.5 (m2) |
FEED AMOUNT: | 20~60 (l/h) | ROTATION SPEED: | 40-250 Rpm |
High Light: | climbing film evaporator,rotary vacuum film evaporator |
20 - 60 l / h Feed Amount Wiped Film Evaporator for CBD / THC / Hemp oil
—— Design
Wiped Film Evaporators are horizontal evaporator with wiper basket, gear motors and external condenser.
The vapour nozzle is typically arranged at the upper end of the evaporator in order to facilitate the transfer of the vapours to the external condenser.
Dea offers thin film evaporators from 0.058 to 3 m2 .
TYPE | BML-10 |
MATERIAL | stainless steel 304 |
TEMPERATURE | Room temp~200/300 ℃(depend on the oil heater) |
DIAMETER | 100 (mm) |
HEAT EXCHANGER HTA | 0.12 (m2) |
FEED AMOUNT | 4000~12000 ( ml/h) |
ROTATION SPEED | 80-390rpm |
FILM SYSTEM | Wiped Filming System |
VACUITY | 0. 5-50mbar(depend on the nature of material and vacuum pump) |
FLOOR AREA | length*width*height=1100*500*1750 (mm)(without pump) |
POWER | 3.5KW (without pump) |
VOLTAGE | 220V -60hz |
The Wiped Film Evaporator is specifically recognized and accepted solution for difficult and challenging processes in the range of distillation, concentration, degassing, drying and reactions. Our Wiped Film Evaporators are developed keeping all the international standards and parameters in check by using optimum grade materials to enhance its productivity.
—— Features
Continuous and trouble-free processing of viscous, fouling and contaminated fluids by high turbulence in the liquid film
Reduces the required temperature difference across the heating surface
Gentle product treatment because of the short residence time and the narrow residence time spectrum in the whole equipment
High evaporation performance because of high surface heat flux
High evaporation ratio in a single pass
Minimum losses in case of product change because of the low hold-up
Contact Person: sales